Tag: “Nest Connection Problem”
Nest connectivity and charging problems solved:
I have two NEST thermostats; one first generation and one second generation. I experienced intermittent connectivity issues with my gen1 Nest soon after I installed it. Initially I determined that it was not charging properly so I brought out the “C” (AC Common) wire from my furnace control board to the NEST and the charging problem was solved. When I installed the gen2 NEST, I made sure the “C” wire was available at installation. I have no charging problems with either NEST now.
Connectivity problems would come and go, sometimes going many weeks or months between incidents. I tried many solutions (port forwarding .lease times, static ip, etc) with varying degrees of success. The connectivity problems were irritating rather than debilitating; most of the time the NEST worked fine. The same pattern occurred after I installed … Read More »
I have two NEST thermostats, one v1 and one v2. The v1 had been ticking along fine until about July 2014 when I began to experience connectivity problems. More specifically, the thermostat itself would say that it was connected properly, but the NEST browser and mobile apps would show it as offline. I tried all the usual fixes: reboot, restart, reset, both (router and NEST), static ip, DHCP Leasetime tweaks, etc. Long story short, nothing I did solved the connectivity issues.
As it turned out, I was reconfiguring my home network and decided to change my main router from a Netgear WNDR4500 to an ASUS RT-AC68U. This change has resolved all my NEST connectivity issues. NEST Connectivity Issues Solved ! Both my NEST thermostats are fully connected and accessible any time I check them. It turns out that the RT-AC68U has … Read More »
Nest thermostat: Should I assign an IP or Not?
The question is: Does assigning the NEST thermostat a static IP using your router result in a more reliable wireless connection? For my first generation NEST running v4.2.3 of the NEST software, the answer is a definite no.
I am using my home router as a DHCP server in order to assign IP addresses to various devices behind it. This is the typical default behavior of most home routers. I like to tweak the setup, however and assign static IP addresses to various devices so that troubleshooting is simplified and IP address conflicts are avoided.
My NEST thermostat connectivity had been generally very good, until a couple of weeks ago when I found that the NEST thermostat could not connect reliably to my router. (I had updated my router firmware about that time as … Read More »